Resultsbee.com

Fixture shutoff valves are located next to or underneath the toilet and sink and can shut off the water supply to these particular fixtures if required. You may need to do so if a sink or toilet is leaking or flooding.

Most likely, you will have to remove the drain flange from the drain. It will have cross hairs, where you can unscrew it using a tool called a spud wrench. If you do not have this tool you could try using the handles of a channel locks. If you remove the drain flange, remove the old systems putty then continue to remove the clog. When you are ready

Several different systems make up a house's water systems. Fresh water is delivered to a home through water supply pipes from the utility or a well and is then distributed to sinks, toilets, washers, bathtubs, and related fixtures. The drain-waste-vent system carries away used water and wastes to sewers or septic tanks.

Typically, a galvanized piping system can last 30-50 years before you will begin to notice poor water quality. Some galvanized systems have started to deteriorate in as little as 3 years; others are 75 years old and look almost new. Lots of factors affect the lifespan of a water system, including the quality of the pipe material and the water quali

An anti-hammer device softens the impact of water rapidly stopping at a point in the water line where an appliance is connected. Appliances rapidly shut water on and off, which causes the water volume to slam into the end of the run and suddenly stop. This creates a hammering affect which can harm the appliance. Modern water systems codes require a

A typical Electrical water heater works on a simple mechanism, a electric heating unit is connected to a 220- volt circuit. To warm up the water, the current is allowed to pass through certain electrical-resistant heating element which is fixed in the middle of the tank. Power is delivered through a thermostat, which controls the water temperature.